Snmp-Server Enable Traps Hg-Lbm - Dell Z9500 Command Reference Manual

snmp-server enable traps hg-lbm

Enable the generation of SNMP traps and notifications when HiGig link-bundle monitoring is enabled.
Z9500
Syntax
snmp-server enable traps hg-lbm
Parameters
hg-lbm
Command
CONFIGURATION mode
Modes
Command
Version
History
9.2.1.0
9.3.0.0
UDP Broadcast
The user datagram protocol (UDP) broadcast feature is a software-based method to forward low
throughput (not to exceed 200 pps) IP/UDP broadcast traffic arriving on a physical or VLAN interface.
Important Points to Remember
• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you configure this feature on an interface using the ip udp-helper udp-port command, the ip
directed-broadcast command becomes ineffective on that interface.
• The existing show interface command has been modified to display the configured broadcast
address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
Z9500
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Interfaces
Enter the keyword hg-lbm to enable traps for HiGig link-
bundle monitoring.
Description
Introduced on the Z9500 switch.
Introduced on the Z9000 platform.
911