Dell Z9500 Command Reference Manual page 103

do
Allows the execution of most EXEC-level commands from all CONFIGURATION levels without returning
to the EXEC level.
Z9500
Syntax
do command
Parameters
command
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage The following commands are not supported by the do command:
Information
•
•
•
•
Example
Dell(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-te-5/0)#
Dell(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Control and Monitoring
Enter an EXEC-level command.
CONFIGURATION
INTERFACE
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
enable
disable
exit
config
103