Gvrp Registration - Dell Z9500 Command Reference Manual

Related disable
Commands

gvrp registration

Configure the GVRP register type.
Z9500
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed
normal
forbidden
Defaults normal
Command CONFIGURATION-INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
Usage
Fixed registration prevents an interface, configured using the command line, to
Information
belong to a VLAN (static configuration) from being unconfigured when it receives a
Leave message. Therefore, Registration mode on that interface is fixed.
Normal registration is the default registration. The port's membership in the VLAN
depends on GVRP. The interface becomes a member of a VLAN after learning
798
— globally disables GVRP.
Enter the keyword fixed then the VLAN range in a comma-
separated VLAN ID set.
Enter the keyword normal then the VLAN range in a
comma-separated VLAN ID set. This setting is the default.
Enter the keyword forbidden then the VLAN range in a
comma-separated VLAN ID set.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
GARP VLAN Registration (GVRP)