Neighbor Subnet - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
8.4.1.0
8.3.19.0
7.8.1.0
7.7.1.0
7.4.1.0
Usage This command enables soft-reconfiguration for the specified BGP neighbor. BGP
Information stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.

neighbor subnet

Enable passive peering so that the members of the peer group are dynamic.
Z9500
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number
mask
Defaults Not configured.
Command ROUTER BGP
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
Border Gateway Protocol
Description
Introduced on the Z9500.
Added support for IPv4 multicast and IPv4 unicast address
families.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
Introduced
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the peer group.
To allow all addresses, enter 0::0/0.
Enter a prefix mask in / prefix-length format (/x).
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
553