Ip Igmp Query-Interval - Dell Z9500 Command Reference Manual

Version
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.6.1.0
7.5.1.0
E-Series legacy
command.

ip igmp query-interval

Change the transmission frequency of IGMP general queries the Querier sends.
Z9500
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds
Defaults 60 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.2(0.0)
9.0.2.0
812
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
Description
Maximum range of the Hello interval value is changed to
18000. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Internet Group Management Protocol (IGMP)