Dell Z9500 Command Reference Manual page 803

summary
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
7.6.1.0
Usage Invalid messages/attributes skipped can occur in the following cases:
Information
•
•
•
•
•
•
A failed registration can occur for the following reasons:
•
•
Example
Dell#show gvrp statistics int te 1/0
Join Empty Received: 0
Join In Received: 0
Empty Received: 0
LeaveIn Received: 0
Leave Empty Received: 0
Leave All Received: 40
GARP VLAN Registration (GVRP)
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword summary to display just a summary of the
GVRP statistics.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on C-Series, E-Series, and S-Series
The incoming GVRP PDU has an incorrect length.
"End of PDU" was reached before the complete attribute could be parsed.
The Attribute Type of the attribute that was being parsed was not the GVRP VID
Attribute Type (0x01).
The attribute that was being parsed had an invalid attribute length.
The attribute that was being parsed had an invalid GARP event.
The attribute that was being parsed had an invalid VLAN ID. The valid range is
from 1 to 4095.
Join requests were received on a port that was blocked from learning dynamic
VLANs (GVRP Blocking state).
An entry for a new GVRP VLAN could not be created in the GVRP database.
803