Ip Igmp Querier-Timeout - Dell Z9500 Command Reference Manual

Version
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
E-Series legacy
command

ip igmp querier-timeout

Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax
ip igmp querier-timeout seconds
To return to the default value, use the no ip igmp querier-timeout
command.
Parameters
seconds
Defaults 125 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.2(0.0)
9.0.2.0
8.3.19.0
Internet Group Management Protocol (IGMP)
Description
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the number of seconds the router must wait to
become the new querier. The range is from 60 to 300. The
default is 125 seconds.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
811