Dell Z9500 Command Reference Manual page 240

[fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
•
•
Parameters
source
mask
any
host ip-address
dscp
bit
operator
port port
240
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no deny tcp {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Enter the IP address of the network or host from which the
packets are sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
Enter a flag or combination of bits:
• ack: acknowledgement field
• fin: finish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent field
(OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for the port command)
Enter the application layer port number. Enter two port
numbers if using the range logical operand. The range is
from 0 to 65535.
The following list includes some common TCP port
numbers:
• 23 = Telnet
Access Control Lists (ACL)