Show Config - Dell Z9500 Command Reference Manual

Command
CONFIGURATION-STANDARD-ACCESS-LIST mode
Modes
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip
udf-qualifier-value ipnip_val1
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
Related
ip access-list standard
Commands
ip access-list extended

show config

Display the current UDF TCAM profile configuration.
Syntax
show config
Command CONFIGURATION-UDF TCAM
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.8(0.0)
Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0
length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
Access Control Lists (ACL)
Description
Introduced on the S6000, Z9500.
— configures a standard ACL.
— creates an extended ACL.
Description
Introduced on the S6000, Z9500.
341