Dell Z9500 Command Reference Manual page 807

Hide thumbs Also See for Z9500:

Table of Contents

vrf vrf-name

group-address

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

E-Series legacy

IGMP commands accept only non-VLAN interfaces — specifying VLAN does not

yield results. This command displays packets for IGMP and IGMP snooping.

Internet Group Management Protocol (IGMP)

(OPTIONAL) Enter the keyword vrf followed by the name of

the VRF to enable debugging of IGMP packets corresponding

to that VRF.

NOTE: Applies to specific VRF if input is provided, else

applies to Default VRF.

(OPTIONAL) Enter the IP multicast group address in dotted

decimal format.

Enter the following keywords and slot/port or number

information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a port channel interface, enter the keywords port-

channel then a number.

Added support for VRF. Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.