Dampening - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

Dell#clear dampening tegigabitethernet 1/10

Clear dampening counters on TeGi 1/10 [confirm] y

show interfaces dampening

dampening

Configure dampening on an interface.

dampening [[[[half-life] [reuse-threshold]] [suppress-

threshold]] [max-suppress-time]]

max-suppress-

INTERFACE (conf-if-)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— displays interface dampening information.

— configures dampening on an interface.

Enter the number of seconds after which the penalty is

decreased. The penalty decreases half after the half-life

period expires. The range is from 1 to 30 seconds. The

default is 5 seconds.

Enter a number as the reuse threshold, the penalty value

below which the interface state is changed to "up". The

range is from 1 to 20000. The default is 750.

Enter a number as the suppress threshold, the penalty value

above which the interface state is changed to "error

disabled". The range is from 1 to 20000. The default is 2500.

Enter the maximum number for which a route can be

suppressed. The default is four times the half-life value. The

range is from 1 to 86400. The default is 20 seconds.