Port-Channel Failover-Group - Dell Z9500 Command Reference Manual

port-channel failover-group

To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
Z9500
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group
command.
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
Usage
This feature groups two LAGs to work in tandem as a supergroup. For example, if
Information
one LAG goes down, the other LAG is taken down automatically, providing an
alternate path to reroute traffic, avoiding oversubscription on the other LAG. You
can use both static and dynamic (LACP) LAGs to configure failover groups. For
more information, refer to the "Port Channel" chapter in the Dell Networking OS
Configuration Guide.
Related
group
Command
show interfaces port-channel
groups.
Interfaces
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
— groups two LAGs in a supergroup ("fate-sharing group").
— displays information on configured Port Channel
897