Dell Z9500 Command Reference Manual page 899

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The following describes the show interfaces port-channel command shown

in the following example.

Port-Channel 1...

Hardware is...

Port-channel is

Internet address...

Members in this...

ARP type:...

Last clearing...

EXEC Privilege

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series. Modified to display the LAG

failover group status.

Introduced on the C-Series.

Displays the LAG's status. In the Example, the status of the

LAG's LAG fate-sharing group ("Failover-group") is listed.

Displays the interface's hardware information and its

assigned MAC address.

Indicates whether the LAG is part of a LAG fate-sharing

group ("Failover-group").

States whether an IP address is assigned to the interface. If

an IP address is assigned, that address is displayed.

Displays link and IP MTU.

Displays the interface's line speed. For a port channel

interface, it is the line speed of the interfaces in the port

Displays the interfaces belonging to this port channel.

Displays the ARP type and the ARP timeout value for the

Displays the time when the show interfaces counters

were cleared.