Dell Z9500 Command Reference Manual page 971

Version
7.9.1.0
7.5.1.0
6.1.1.0
Usage The following describes the show ip fib command shown in the following
Information
example.
Field
Destination
Gateway
First-Hop
Mac-Addr
Port
VId
Index
EC
Example
Dell>show ip fib linecard 2
Destination
Port
---------------------------------------------------------------
-----------------
3.0.0.0/8
00:01:e8:00:03:ff So 2/8 0 60260 0
3.0.0.0/8
00.10.10.0/24
00:01:e8:00:03:ff So 2/8 0 11144 0
100.10.10.1/32
00:00:00:00:00:00 CP
100.10.10.10/32 via 100.10.10.10, So 2/8 100.10.10.10
00:01:e8:00:03:ff So 2/8 0 0
101.10.10.0/24
00:00:00:00:00:00 RP2
101.10.10.1/32
00:00:00:00:00:00 CP
101.10.10.10/32 via 101.10.10.10, So 2/9 101.10.10.10
00:01:e8:01:62:32 So 2/9 0 1
Dell>
Related clear ip fib linecard
Commands
IPv4 Routing
Description
Introduced VRF on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Lists the destination IP address.
Displays either the word "direct" and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
Displays the first hop IP address.
Displays the MAC address.
Displays the egress-port information.
Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
Displays the internal interface number.
Displays the number of ECMP paths.
Gateway
VId Index EC
via 100.10.10.10, So 2/8 100.10.10.10
via 101.10.10.10, So 2/9
Direct, So 2/8 0.0.0.0
via 127.0.0.1 127.0.0.1
Direct, So 2/9 0.0.0.0
via 127.0.0.1 127.0.0.1
— clears the FIB entries on a specified line card.
First-Hop
0 3276 0
0
0 11145 0
0 3277 0
0
Mac-Addr
971