Defaults
Not configured.
Command
ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
7.8.1.0
7.7.1.0
Usage
You can use the redistribute command to advertise the IGP cost as the MED
Information
on redistributed routes. When you set the route-map with metric-type internal and
applied outbound to an EBGP peer/peer-group, the advertised routes
corresponding to those peer/peer-groups have the IGP cost set as MED.
If you do not configure the default-metric command, in addition to the
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is "0".
To redistribute the default route (0.0.0.0/0), configure the neighbor default-
originate command.
As BGP does not query next-hop information corresponding to locally originated
routes, a local route with an unreachable next-hop is chosen as the best route.
442
•
match ip address
•
set community
•
set local-preference
•
set metric
•
set next-hop
•
set origin
•
set weight
If the route map is not configured, the default is deny (to
drop all routes).
Description
Introduced on the S6000–ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol