Redistribute - Dell Z9500 Command Reference Manual

redistribute

Redistribute routes into BGP.
Z9500
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map map-name] command.
Parameters
connected
static
route-map
map-name
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
7.4.1.0
Usage
If you do not configure the default-metric command in addition to the
Information
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is "0".
To redistribute the default route (0::0/0), configure the neighbor default-
originate command.
560
Enter the keyword connected to redistribute routes from
physically connected interfaces.
Enter the keyword static to redistribute manually
configured routes. These routes are treated as incomplete
routes.
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Description
Introduced on the Z9500.
Introduced
Border Gateway Protocol