Dell Z9500 Command Reference Manual page 227

Hide thumbs Also See for Z9500:

Table of Contents

threshold-in

Not configured.

CONFIGURATION-STANDARD-ACCESS-LIST

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Access Control Lists (ACL)

(OPTIONAL) Enter the keyword order to specify the QoS

priority for the ACL entry. The range is from 0 to 254 (where

0 is the highest priority and 254 is the lowest; lower-order

numbers have a higher priority). If you do not use the

keyword order, the ACLs have the lowest order by default

Enter the keyword fragments to use ACLs to control packet

(OPTIONAL) Enter the keyword log to include ACL

messages in the log.

(OPTIONAL) Enter the threshold-in-msgs keyword

followed by a value to indicate the maximum number of ACL

logs that can be generated, exceeding which the generation

of ACL logs is terminated with the seq, permit, or deny

commands. The threshold range is from 1 to 100.

(OPTIONAL) Enter the keyword interval followed by the

time period in minutes at which ACL logs must be generated.

The threshold range is from 1 to 10 minutes.

(OPTIONAL) Enter the keyword monitor when the rule is

describing the traffic that you want to monitor and the ACL

in which you are creating the rule is applied to the monitored

interface. For more information, refer to the "Flow-based

Monitoring" section in the Port Monitoring chapter of the

Dell Networking OS Configuration Guide.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Add the DSCP value for ACL matching.

Allows ACL control of fragmented packets for IP (Layer 3)

Introduced on the E-Series ExaScale.