Dell Z9500 Command Reference Manual page 181

Hide thumbs Also See for Z9500:

Table of Contents

ipv6-address

prefix-length

vrf instance

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Control and Monitoring

Enter the IPv6 address in the x:x:x:x::x format then the prefix

length in the /x format. The range is from /0 to /128.

(Optional) Enter the keyword vrf then the VRF instance

(OPTIONAL) Enter the keywords /source-interface then

the interface information to include the source interface.

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from zero (0) to 16383.

For the Null interface, enter the keyword null then 0.

For a Port Channel interface, enter the keyword port-

channel then a number. The range is from 1 to 128.

For Tunnel interface types, enter the keyword tunnel

then the slot/ port information. The range is from 1 to

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

EXEC Privilege

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the S4810. Added support for source-

interface for link-local IPv6 addressing.

Introduced on the Z9000.

Introduced on the E-Series ExaScale (IPv6). Increased the

number of VLANs on ExaScale to 4094 (was 2094).

NOTE: The :: notation specifies successive hexadecimal

fields of zeros.