Ip Dhcp Snooping Database - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

ipv6 ipv6-address interface interface-type | interface-number

lease valuecommand.

interface type

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

ip dhcp snooping database

Delay writing the binding table for a specified time.

ip dhcp snooping database write-delay minutes

Enter the keyword mac then the MAC address of the host to

which the server is leasing the IPv6 address.

Enter the keywords vlan-id then the VLAN to which the

host belongs. The range is from 2 to 4094.

Enter the keyword ipv6 then the IPv6 address that is leased

to the client.

Enter the keyword interface then the type of interface to

which the host is connected:

For an 10/100 Ethernet interface, enter the keyword

fastethernet.

For a Gigabit Ethernet interface, enter the keyword

gigabitethernet.

For a Ten-Gigabit Ethernet interface, enter the keyword

tengigabitethernet.

For a 40-Gigabit Ethernet interface, enter the keyword

Enter the number of the interface.

Enter the keyword lease then the amount of time the IPv6

address are leased. The range is from 1 to 4294967295.

EXEC Privilege

Introduced on the S4810, S4820T, S6000 and Z-Series.

Dynamic Host Configuration Protocol (DHCP)