Linecard Portmode - Dell Z9500 Command Reference Manual

linecard portmode

Split a single 40G port into four 10G ports on the switch.
Z9500
Syntax
linecard slot-id port number portmode quad
Parameters
linecard slot-id
number
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
Usage
Enabling quad mode on a port removes the interface configurations (if any) on the
Information
port after a save and reload. Be sure that the port is removed from other L2 and L3
feature configurations.
You can dynamically fan-out the 40G to 4x10G and vice versa without reload.
This command cannot be used if LR4 optics are inserted in the 40G port.
monitor interface
Monitor counters on a single interface or all interfaces on a line card. The screen is refreshed every five
seconds and the CLI prompt disappears.
Z9500
Syntax
monitor interface [interface] [linecard slot-id]
To disable monitoring and return to the CLI prompt, press the q key.
854
Enter the slot ID of a Z9500 line card to reset. The range of
slot IDs is from 0 to 2.
Enter the port number of the 40G port to be split. A 40G port
number is a multiple of 4; for example, 0, 4, 8, 12, ... 120, 124,
128).
Description
Dynamically fan-out feature is added.
Introduced on the Z9500.
Interfaces