Management Route - Dell Z9500 Command Reference Manual

Related hash-algorithm ecmp
Commands

management route

Configure a static route that points to the Management interface or a forwarding router.
Z9500
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet |
fortyGigE | vlan | tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask
| {ipv6-address prefix-length}}{forwarding-router-address |
managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet} command.
Parameters
ip-address
mask
ipv6-address
prefix-length
forwarding-
router-address
managementet
hernet
fortyGigE
vlan
tengigabitether
net
Defaults Not configured.
Command CONFIGURATION
Modes
960
— changes the hash algorithm across an ECMP.
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
Enter the keyword managementethernet for the
Management interface on the Primary RPM.
Enter the keyword fortyGigE to specify a forty Gigbit
Ethernet interface.
Enter the keyword vlan to specify a vlan interface.
Enter the keyword tengigabitethernet to specify a ten Gigabit
Ethernete interface.
IPv4 Routing