Redistribute Ospf - Dell Z9500 Command Reference Manual

Related neighbor default-originate
Commands

redistribute ospf

Redistribute OSPFv3 routes into BGP.
Z9500
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id
match external
{1 | 2}
match internal
route-map
map-name
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version
History
9.2(1.0)
8.2.1.0
7.4.1.0
Border Gateway Protocol
– injects the default route.
Enter the number of the OSPFv3 process. The range is 1 to
65535.
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
(OPTIONAL) Enter the keywords match internal to
redistribute OSPFv3 internal routes only.
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to
drop all routes).
Description
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
561