Dell Z9500 Command Reference Manual page 650

level2
interactive
testname name
terminate
Defaults All offline diagnostic tests are run on all Z9500 CPUs (Control Processor, Route
Processor, and line cards).
Command EXEC Privilege
Modes
Usage
Before you use this command to run diagnostic test, make sure the switch is offline
Information
(offline system command).
You are prompted to reboot when the off-line diagnostics complete.
Use the show diag command to view a summary of diagnostic information
presented for each Z9500 CPU.
At the end of offline diagnostic tests, a test report is generated. The filename of the
report is TestReport-{CP/LP/RP}-N.txt, where {CP/LP/RP}-N identifies the CPU and
CPU ID on which the diagnostics were run: Route Processor 0, Control Processor
0 or a line-card CPU {0–2}. The report is stored at flash:// and ramdisk:/diagnostic.
To view the test report, use the show file flash://filenamecommand. A
sample filename is TestReport-LP-2.
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(1.0)
Version
8.3.19.0
Version 8.3.11.1
650
Enter the keyword level2 to run Level 2 diagnostics. Level 2
diagnostics are a full set of diagnostic tests with no support
for automatic partitioning. Level 2 diagnostics are used
primarily for on-board loopback tests and more extensive
component diagnostics. Various components on the board
are put into Loopback mode and test packets are transmitted
through those components. These diagnostics also perform
snake tests using VLAN configurations.
Enter the keyword interactive to run offline diagnostics in
interactive mode.
Enter the testname name parameters to run a specified
offline diagnostic test. Enclose the test-case name in double
quotes (" "). For example: diag level1 testname
"first".
Enter the keyword terminate to stop the offline diagnostic
tests that are running.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Debugging and Diagnostics