Ip Dhcp Snooping Vlan - Dell Z9500 Command Reference Manual

Version
9.7(0.0)

ip dhcp snooping vlan

Enable DHCP Snooping on one or more VLANs.
Z9500
Syntax
[no] ip dhcp snooping vlan name
Parameters
name
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.11.1
8.3.1.0
7.8.1.0
Usage When enabled, the system begins creating entries in the binding table for the
Information specified VLANs.
Related ip dhcp snooping trust
Commands
ipv6 dhcp snooping vlan
Enable ipv6 DHCP Snooping on VLAN or range of VLANs.
Syntax
[no] ip dhcp snooping vlan vlan-id
To disable the ipv6 dhcp snooping on VLAN basis or range of VLAN, use the no
ipv6 dhcp snooping vlan <vlan-id> command.
Dynamic Host Configuration Protocol (DHCP)
Description
Introduced on the S4810, S4820T, S6000 and Z-Series.
Enter the name of a VLAN on which to enable DHCP
Snooping.
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
NOTE: Learning only happens if there is a trusted port in the VLAN.
— configures an interface as trusted.
733