Dell Z9500 Command Reference Manual page 215

Parameters
remark-
number
description
Defaults Not configured.
Command
•
Modes
•
•
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.4.1.0
Usage The remark command is available in each ACL mode. You can configure up to
Information 4294967290 remarks in a given ACL.
The following example shows the use of the remark command twice within
CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number
was used for the remark and for an associated ACL rule. The remark precedes the
rule in the running-config because it is assumed that the remark is for the rule with
the same sequence number, or the group of rules that follow the remark.
Example
Dell(config-std-nacl)#remark 10 Deny rest of the traffic
Dell(config-std-nacl)#remark 5 Permit traffic from XYZ Inc.
Dell(config-std-nacl)#show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 Deny any
Dell(config-std-nacl)#
Access Control Lists (ACL)
Enter the remark number. The range is from 0 to 65535.
Enter a description of up to 80 characters.
CONFIGURATION-IP ACCESS LIST-STANDARD
CONFIGURATION-IP ACCESS LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: You can use the same sequence number for the
remark and an ACL rule.
215