Ipv6 Helper-Address - Dell Z9500 Command Reference Manual

Usage
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source
Information
Address Validation.
1.
2.
3.

ipv6 helper-address

Configures the ipv6 DHCP helper addresses without VRF.
Syntax
[no] ipv6 helper-address ipv6-address
To delete the ipv6 helper address, use the [no] ipv6 helper-address ipv6-
address command.
Parameters
ipv6-address
Default Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
Use this command on the interfaces where the DHCP clients are connected to
Information
forward the packets from clients to DHCP server and vice-versa.
Example
Dell(conf-if-te-0/0)#ipv6 helper-address
X:X:X:X::X
VRF
Global
Dynamic Host Configuration Protocol (DHCP)
Use the cam-acl l2acl command from CONFIGURATION mode.
Save the running-config to the startup-config.
Reload the system.
Enter the keywordipv6–address through which the server
address can be reached.
Description
Introduced on the S4810, S4820T, S6000, S6000–ON,
Z9000, and Z9500.
IPv6 helper address
VRF name.
Global address space
735