Minimum-Links - Dell Z9500 Command Reference Manual

shutdown

minimum-links

Configure the minimum number of links in a LAG (Port Channel) that must be in "oper up" status for the
LAG to be also in "oper up" status.
Z9500
Syntax
minimum-links number
Parameters
number
Defaults 1
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.2.1.0
Usage
If you use this command to configure the minimum number of links in a LAG that
Information
must be in "oper up" status, the LAG must have at least that number of "oper up"
links before it can be declared as up. For example, if the required minimum is four,
and only three are up, the LAG is considered down.
896
— disables/enables the port channel.
Enter the number of links in a LAG that must be in "oper up"
status. The range is from 1 to 16. The default is 1.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Interfaces