Crypto Ipsec Policy - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
9.2(0.0)
Usage
•
Information
•
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64

crypto ipsec policy

Create a crypto policy used by ipsec.
Z9500
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-
num ipsec-manual command.
Parameters
name
seq-num
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2(0.0)
Internet Protocol Security (IPSec)
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Both sides of the link must specify the same transform set.
You can create up to 64 transform sets.
Enter the name for the crypto policy set.
Enter the sequence number assigned to the crypto policy
entry.
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
917