Permit Icmp (For Ipv6 Acls) - Dell Z9500 Command Reference Manual

permit icmp (for IPv6 ACLs)

To allow all or specific internet control message protocol (ICMP) messages, configure a filter.
Syntax
permit icmp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} [message-type]
[count [byte]] [log [interval minutes] [threshold-in-msgs
[count]] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
log
threshold-in
msgs count
interval
minutes
monitor
Defaults By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Command ACCESS-LIST
Modes
Command
Version 9.5(0.1)
History
Version 9.4(0.0)
Version 9.3(0.0)
1004
Use the no seq sequence-number command if you know the filter's
sequence number.
Use the no permit icmp {source address mask | any | host ipv6-
address} {destination address | any | host ipv6-address}
command.
(OPTIONAL) Enter the keyword log to enable the triggering
of ACL log messages.
(OPTIONAL) Enter the threshold-in-msgs keyword
followed by a value to indicate the maximum number of ACL
logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
(OPTIONAL) Enter the keyword interval followed by the
time period in minutes at which ACL logs must be generated.
The interval range is from 1 to 10 minutes.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
Introduced on the Z9500.
Added support for flow-based monitoring on the S4810,
S4820T, S6000, and Z9000 platforms.
Added support for logging of ACLs on the S4810, S4820T,
and Z9000 platforms.
IPv6 Access Control Lists (IPv6 ACLs)