Dell Z9500 Command Reference Manual page 224

Command CONFIGURATION-STANDARD-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
7.4.1.0
6.5.1.0
Usage
Use the order option only when you use policy-based QoS on the switch. For
Information
more information, refer to the Quality of Service chapter of the Z9500
Configuration Guide.
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets' details.
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default,
flow-based monitoring is not enabled.
Use the monitor option only when you are using flow-based monitoring. For
more information, refer to the Port Monitoring chapter of the Z9500 Configuration
Guide.
The software cannot count both packets and bytes, so when you enter the count
byte options, only bytes are incremented.
Related
ip access-list standard
Commands
224
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the
ACL entry.
— configures a standard ACL.
Access Control Lists (ACL)