Dell Z9500 Command Reference Manual page 597

Hide thumbs Also See for Z9500:

Table of Contents

queue-number

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

In the show output, Rx Bytes displays the number of bytes of control-plane traffic

received, on which queue-based rate limiting is applied. Tx Counters displays the

number of bytes transmitted to a control-plane CPU after queue-based rate

limiting is applied. Drop Counters displays the number of bytes of control-plane

traffic that have been dropped as a result of queue-based rate limiting.

To clear the per-queue counters of rate-limited control-plane traffic at the

aggregated (switch) or line card and port set level, use the clear control-

traffic queue command.

Dell#show control-traffic queue queue-id 0 counters

---------------------------------------------------------

Control Plane Policing (CoPP)

Enter the keyword all to display counters for rate-limited

traffic on all CPU queues, including Route Processor, Control

Processor, and line-card CPUs.

Enter the queue number to display counters for rate-limited

traffic on a specified CPU queue. The range of queue-

number values is from 0 to 23. The twenty-four control–

plane queues are divided into groups of eight queues for the

Route Processor, Control Processor, and line-card CPUs as

Queues 0 to 7 process packets destined to the Control

Processor CPU .

Queues 8 to 15 process packets destined to the Route

Processor CPU.

Queues 16 to 23 process packets destined to the line

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Drop counter