Group - Dell Z9500 Command Reference Manual

Usage
Use the interface port-channel command to access this command.
Information
You cannot add an interface to a Port Channel if the interface contains an IP
address in its configuration. Only the shutdown, description, mtu, and ip mtu
commands can be configured on an interface if it is added to a Port Channel. The
mtu and ip mtu commands are only available when the chassis is in Jumbo mode.
Link MTU and IP MTU considerations for Port Channels are:
•
•
When an interface is removed from a Port Channel with the no channel-member
command, the interface reverts to its configuration prior to joining the Port
Channel.
An interface can belong to only one Port Channel.
Related
description
Commands
interface port-channel
shutdown

group

Group two LAGs in a supergroup ("fate-sharing group" or "failover group").
Z9500
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number
port-channel
number
Defaults none
Command PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Modes
Interfaces
All members must have the same link MTU value and the same IP MTU value.
The Port Channel link MTU and IP MTU must be less than or equal to the link
MTU and IP MTU values configured on the channel members. For example, if
the members have a link MTU of 2100 and an IP MTU 2000, the Port Channel's
MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
— assigns a descriptive text string to the interface.
— creates a Port Channel interface.
— disables/enables the port channel.
Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
893