Debug Ip Dhcp - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.3.1.0
Usage To stop packets from flooding the user terminal when debugging is turned on, use
Information the count option.

debug ip dhcp

Enable debug information for dynamic host configuration protocol (DHCP) relay transactions and display
the information on the console.
Z9500
Syntax
debug ip dhcp
To disable debug, use the no debug ip dhcp command.
Defaults Debug disabled
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
IPv4 Routing
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Added support for 4094 VLANs on the E-Series ExaScale
(the prior limit was 2094).
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the count option.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
935