Dell Z9500 Command Reference Manual page 847

Hide thumbs Also See for Z9500:

Table of Contents

interface,...

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter the keywords interface range and one of the

interfaces — slot/port, port-channel, or VLAN number. Select

the range of interfaces for bulk configuration. You can enter

up to six comma-separated ranges. Spaces are not required

between the commas. Comma-separated ranges can

include VLANs, port-channels, and physical interfaces.

Slot/Port information must contain a space before and after

the dash. For example, interface range

tengigabitethernet 0/1 - 5 is valid; interface

range tengigabitethernet 0/1-5 is NOT valid.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

For a Tunnel interface, enter the keyword Tunnel then a

number from 1 to 16383.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Added support for 4093 VLANs on E-Series ExaScale. Prior

releases supported 2094.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.