As-Path Commands - Dell Z9500 Command Reference Manual

AS-Path Commands

The following commands configure AS-Path ACLs.
ip as-path access-list
Enter AS-PATH ACL mode and configure an access control list based on the BGP AS_PATH attribute.
Z9500
Syntax
ip as-path access-list as-path-name
Parameters
as-path-name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
6.1.1.0
Usage To apply the AS-PATH ACL to BGP routes, use the match as-path or neighbor
Information
filter-list commands.
Example
Dell(conf)#ip as-path access-list TestPath
Dell(config-as-path)#
Related
match as-path
Commands
neighbor filter-list
Access Control Lists (ACL)
Enter the access-list name, up to 140 characters.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the E-Series.
— matches on routes contain a specific AS-PATH.
— configures filter based on AS-PATH information.
333