Cam-Acl (Configuration) - Dell Z9500 Command Reference Manual

When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP 3.0, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.

cam-acl (Configuration)

Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6
ACLs, Layer 2 and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address
validation for DHCP, Ethernet Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based
Routing (PBR).
Z9500
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number ecfmacl
number [nlbclusteraclnumber][vman-qos | vman-dual-qos number]
ipv4pbr number}openflow {4|8} | fcoe number}
Parameters
default
94
Use the default CAM profile settings and set the CAM as
follows:
• L3 ACL (ipv4acl): 4
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
• nlbclusteracl: 2
• OpenFlow: 0 (disabled)
Control and Monitoring