Ssp Control Register 1 (Sscr1); Sscr1 Bit Definitions - Intel PXA255 Developer's Manual

8.7.1.5 Serial Clock Rate (SCR)
The 8-bit serial clock rate (SCR) bit-field is used to select the SSPC bit rate. The SSPC has 256 bit
rates, from 7.2 Kbps to 1.8432 Mbps. The serial clock generator uses the internal 3.6864 MHz
clock or an external clock provided through SSPEXTCLK. The clock is divided by 2, then divided
by the programmable SCR value (0 to 255) plus 1 to generate the serial clock (SSPSCLK). The
resultant clock is driven on the SSPSCLK pin and is used by the SSP's transmit logic to drive data
on the SSPTXD pin and to latch data on the SSPRXD pin. Depending on the frame format selected,
each transmitted bit is driven on either SSPSCLK's rising or falling edge and sampled on the
opposite clock edge.
This is a read/write register. Ignore reads from reserved bits. Write zeros to reserved bits.
8.7.2

SSP Control Register 1 (SSCR1)

SSCR1, shown in
Table 8-3. SSCR1 Bit Definitions (Sheet 1 of 2)
0x4100_0004
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9
Reset
Bits Name
0
RIE
1 TIE
2 LBM
3 SPO
4 SPH
5 MWDS
Intel® PXA255 Processor Developer's Manual
Table 8-3, contains bit fields that control SSP functions.
SSP Control Register 1 (SSCR1)
reserved
X
Receive FIFO Interrupt Enable
0 = Receive FIFO interrupt is disabled
1 = Receive FIFO interrupt is enabled
Transmit FIFO Interrupt Enable
0 = Transmit FIFO interrupt is disabled
1 = 1 - Transmit FIFO interrupt is enabled
Loop-Back Mode
0 = Normal serial port operation enabled
1 = Output of transmit serial shifter internally connected to input of receive serial shifter
Motorola SPI SSPSCLK polarity setting:
0 = The inactive or idle state of SSPSCLK is low.
1 = The inactive or idle state of SSPSCLK is high.
Motorola SPI SSPSCLK phase setting:
0 = SSPSCLK is inactive one cycle at the start of a frame and 1/2 cycle at the end of a
frame.
1 = SSPSCLK is inactive 1/2 cycle at the start of a frame and one cycle at the end of a
frame.
Microwire Transmit Data Size:
0 = 8-bit command words are transmitted.
1 = 16-bit command words are transmitted.
Synchronous Serial Port Controller
Synchronous Serial Port Controller
8 7 6
RFT TFT
0x0 0x0
Description
5 4 3 2 1 0
0 0 0 0 0 0
8-11