Intel PXA255 Developer's Manual page 157

Intel computer hardware user manual
Hide thumbs Also See for PXA255:
Table of Contents

Advertisement

a. Word [0] -> DDADRx register and a single flag bit. Points to the next four-word
descriptor.
b. Word [1] -> DSADRx register for the current transfer.
c. Word [2] -> DTADRx register for the current transfer.
d. Word [3] -> DCMDx register for the current transfer.
6. The channel waits for the request or starts the data transfer, as determined by the
DCMD[FLOW] source and target bits.
7. The channel transmits a number of bytes equal to the smaller of DCMD[SIZE] and
DCMD[LENGTH].
8. The channel waits for the next request or continues with the data transfer until the
DCMD[LENGTH] reaches zero.
9. The channel stops or continues with a new descriptor fetch from the memory, as determined by
the DDADR[STOP] bit.
Bit [0] (STOP) of Word [0] in a DMA descriptor (the low bit of the DDADRx field) marks the
descriptor at the end of a descriptor list. The value of the STOP bit does not affect the manner in
which the channel's registers load the descriptor's fields. If a descriptor with its STOP bit set is
loaded into a channel's registers, the channel stops after it completely transfers the data that
pertains to that descriptor.
Software must set the DCSR[RUN] bit to 1 after it loads the DDADR. The channel descriptor fetch
does not take place unless the DDADR register is loaded and the DCSR[RUN] bit is set to a 1.
The DMAC priority scheme does not affect DMA descriptor fetches. The next descriptor is fetched
immediately after the previous descriptor is serviced.
Intel® PXA255 Processor Developer's Manual
Figure 5-4
summarizes this operation.
DMA Controller
5-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents