Configuring Internet Explorer; Supported Switches - Brocade Communications Systems Brocade 300 Administrator's Manual

Configuring Internet Explorer

Correct operation of EZSwitchSetup Switch Manager with Internet Explorer requires specifying the
appropriate settings for browser refresh frequency and process model. Browser pages should be
refreshed frequently to ensure the correct operation of Switch Manager.
1. Select Tools > Internet Options.
2. Select the General tab.
3. Click the Settings button under "Browsing history."
4. Click Every time I visit the webpage under "Check for newer versions of stored pages," as
5. Click OK to save the changes.

Supported switches

You can use EZSwitchSetup with the switches listed in
page v.
Your switch must meet the following requirements:
•
•
EZSwitchSetup Administrator's Guide
53-1002744-01
shown in Figure 2.
FIGURE 2
Configuring Internet Explorer
It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system
issues the message "Page not Found."
It must have licensed FC ports. If the switch has no licensed FC ports, you must first install a
POD license and then enable the affected ports. For more information, refer to
license" on page 38
Supported switches
"Supported hardware and software"
1
on
"Adding a port
3