Cisco SR2016T-NA Reference Manual page 145

Chapter 2 Cisco CMTS Configuration Commands
cable load-balance group (interface configuration)
To assign a downstream cable interface to a load-balance group, use the cable load-balance group
command in interface configuration mode. To remove a downstream from a load-balance group, use the
no form of this command.
Syntax Description n
Defaults A downstream is not assigned to a load-balance group. When you use this command to add a downstream
to a group, it also automatically adds all of the associated upstreams to the same group, unless you have
also used the
Command Modes Interface configuration (cable interface only)
Command History Release
12.2(15)BC1
Usage Guidelines After you have used the
and configure a load-balance group, use the
command to assign this load-balance group to a downstream. This enables the cable interface to begin
participating in load-balancing operations.
Use the
Tip
upstream.
The following rules apply when creating and assigning load-balance groups:
•
•
OL-1581-08
cable load-balance group n
no cable load-balance group n
Specifies the number of the load-balance group to which the downstream
should be assigned. The valid range is 1 to 20.
cable upstream load-balance group
Modification
This command was introduced for the Cisco uBR7246VXR and
Cisco uBR10012 routers.
cable load-balance group (global configuration)
cable upstream load-balance group
A downstream or upstream can belong to only one load-balance group.
All downstreams and upstreams in a load-balance group must share physical radio frequency (RF)
connectivity to the same group of cable modems. Downstreams can be in a separate load-balance
group than upstreams, but all downstreams or all upstreams that have the same RF physical
connectivity must be members of the same load-balance group. You cannot distribute downstreams
or upstreams that share physical connectivity across multiple load-balance groups.
cable load-balance group (interface configuration)
command to assign the upstreams to different groups.
cable load-balance group (interface configuration)
command to assign this load-balance group to an
Cisco Broadband Cable Command Reference Guide
command to initially create
2-133