Cisco SR2016T-NA Reference Manual page 115

Chapter 2 Cisco CMTS Configuration Commands
cable flap-list size
To specify the maximum number of CMs that can be displayed from the flap-list table, use the cable
flap-list size command in global configuration mode. To specify the default flap-list table size, use the
no form of this command.
Syntax Description number
Defaults 100
Command Modes
Global configuration
Command History Release
12.1 T
Usage Guidelines
Examples The following example shows how to display a maximum of 200 flap-list entries :
Router# configure terminal
Router(config)# cable flap-list size 200
Router(config)#
Related Commands Command
cable flap-list aging
cable flap-list
insertion-time
cable flap-list miss-
threshold
cable flap-list power-
adjust threshold
clear cable flap-list
debug cable flap
OL-1581-08
cable flap-list size number
no cable flap-list size
Modification
This command was introduced.
Description
Specifies the number of days to keep a CM in the flap-list table before aging
it out of the table.
Sets the insertion time interval that determines whether a CM is placed in the
flap list.
Specifies miss threshold for recording a flap-list event.
Specifies the power-adjust threshold for recording a CM flap-list event.
Clears all the entries in the flap-list table.
Displays information about the operation of the CM flap list that is
maintained for the cable interfaces.
Specifies the maximum number of CMs to be displayed. Valid values
are from 1 to 8191, with a default of 100 CMs.
Cisco Broadband Cable Command Reference Guide
cable flap-list size
2-103