Table of Contents
Advertisement
cable event priority
The following commands configure the Cisco CMTS so that it reports the lowest priority messages only
to the local volatile log and SYSLOG server:
Router# configure terminal
Router(config)# cable event priority debug 0x30
Router(config)# cable event priority informational 0x30
Router(config)# cable event priority notice 0x30
Router(config)#
Related Commands
Command
cable event syslog-server
cable event throttle-
adminStatus
cable event throttle-interval
cable event throttle-
threshold
snmp-server enable traps
cable
snmp-server enable traps
docsis-cmts
Cisco Broadband Cable Command Reference Guide
2-82
Description
Enables logging of DOCSIS event messages to a SYSLOG server.
Configures how the Cisco CMTS throttles the SNMP traps and
SYSLOG messages it generates for DOCSIS event messages.
Specifies the throttle interval, which helps control how often the
Cisco CMTS generates SNMP traps and SYSLOG messages for
DOCSIS event messages.
Sets the maximum number of SNMP traps and SYSLOG messages
that the Cisco CMTS can generate for DOCSIS event messages during
the throttle interval.
Enables traps for cable-related events.
Enables traps for DOCSIS-related MAC-layer events.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
