Table of Contents
Advertisement
Default Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Port rate limiting can only be configured on Cisco MDS 9100 Series switches, Cisco MDS 9216i
Note
switches, and MPS-14/2 modules.
This feature can only be configured if the QoS feature is enabled and if this configuration is performed
on a Cisco MDS 9100 series switch, Cisco MDS 9216i switch, or MPS-14/2 module.
To configure the port rate limiting value, follow these steps.
Command
Step 1
switch # config t
switch(config)#
Step 2
switch(config)# interface fc 1/1
Step 3
switch(config-if)# switchport ingress-rate 50
switch(config-if)# no switchport ingress-rate 50
Default Settings
Table 47-2
.
Table 47-2
Parameters
FCC protocol
QoS control traffic
QoS data traffic
Zone-based QoS priority
Rate limit
Cisco MDS 9000 Family Configuration Guide
47-14
lists the default settings for FCC, QoS, and rate limiting features:
Default FCC, QoS, and Rate Limiting Settings
Chapter 47
Configuring Fabric Congestion Control and QoS
Purpose
Enters the configuration mode.
Selects the interface to specify the ingress
port rate limit.
Configures a 50% port rate limit for the
selected interface.
Reverts a previously configured rate to the
factory default of 100%.
Default
Disabled.
Enabled.
Disabled.
Low.
100%
OL-6973-03, Cisco MDS SAN-OS Release 2.x
Advertisement
Table of Contents
