Default Basic Settings - Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Hardware Installation Manual

Default Basic Settings

Press sn and then press Enter to select SNMP Admin. Community. Enter an SNMP community name.
Step 14
This name automatically appears in the list of users authorized to view and make changes to the bridge's
management system. Press Enter when you have completed your entry.
You can define other SNMP communities with User Management. The "Security Setup" section in
Chapter 3 of the Cisco Aironet 350 Series Bridge Software Configuration Guide describes User
Management.
Press ap and press Enter to apply your basic settings. If you changed the Role in Radio Network setting,
Step 15
your bridge reboots.
Close your Telnet session by closing the Telnet window.
Step 16
Default Basic Settings
Table 3-2
Cisco Aironet 350 Series Bridge Hardware Installation Guide
3-16
lists the default settings on the bridge's Express Setup page.
Table 3-2
Setting Name
System Name
Terminal Type (Console interface only) teletype
Config Server Protocol
IP address
IP Subnet Mask
Default Gateway
SSID
Role in Radio Network
Optimize Radio Network For
Ensure Compatibility With
SNMP Admin. Community
Default Settings on the Express Setup Page
Default Value
AIR-BR350_xxxxxx (the last six
characters of the unit's MAC address)
DHCP
10.0.0.1
255.255.255.0
255.255.255.255
tsunami
Root Bridge
Throughput
(not configured)
(not configured)
Chapter 3 Basic Configuration
OL-1412-01