Table of Contents
Advertisement
Virtual Private Networks (VPN)
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show IPsec status and statistics
WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. On the menu, select Status > IPsec.
The IPsec page appears.
3. To view configuration details about an IPsec tunnel, click the (configuration) icon in the
upper right of the tunnel's status pane.
Command line
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured IPsec tunnels, type the following at the prompt:
> show ipsec all
Name
------
ipsec1
vpn1
>
3. To display details about a specific tunnel:
> show ipsec tunnel ipsec1
Tunnel
Enable
Status
Hostname
Zone
Mode
Type
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX20 User Guide
Enable
Status
Hostname
------
-------
---------------
true
up
192.168.2.1
false
pending
192.168.3.1
: ipsec1
: true
: pending
: 192.168.2.1
: ipsec
: tunnel
: esp
IPsec
325
Advertisement
Table of Contents
