Show Surelink Status For All Ipsec Tunnels; Show Surelink Status For A Specific Ipsec Tunnel - Digi IX14 User Manual

Interfaces
> show surelink interface name LAN
Interface
---------
LAN
LAN
Passingsing
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show Surelink status for all IPsec tunnels

To show the Surelink status all IPsec tunnels, use the
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink ipsec all
IPsec
------
test
test
test1
test2
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show Surelink status for a specific IPsec tunnel

To show the Surelink status a specific IPsec tunnel, use the
command:
1. Log into the IX14 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show surelink ipsec tunnel name
tunnel, for example:
IX14 User Guide
Test
-----------------------------
Interface is up
Interface's DNS servers (DNS)
Test
--------------------
194.43.79.74 (Ping)
194.43.79.75 (Ping)
194.43.79.74 (Ping)
194.43.79.75 (Ping)
Show Surelink status and statistics
Proto Last Response
----- -------------
IPv4 32 seconds
IPv4 28 seconds
show surelink ipsec all
Last Response Status
------------- ------------------
29 seconds Passed
5 seconds Passed
21 seconds Failed
21 seconds Waiting for result
show surelink ipsec tunnel name
command to show the Surelink status of a specific
Status
-------
Passing
command:
150