Table of Contents
Advertisement
Interfaces
b. Add the device:
(config network vlan vlan1)> device /network/device/
(config network vlan vlan1)>
5. Set the VLAN ID:
(config network vlan vlan1)> id value
where value is an integer between 1 and 4095.
6. Save the configuration and apply the change:
(config network vlan vlan1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show Surelink status and statistics
You can show Surelink status for all interfaces, or for an individual interface. You can also show
Surelink status for ipsec tunnels and OpenVPN clients.
Surelink status is only available from the Admin CLI.
Command line
Show Surelink status for all interfaces
To show the Surelink status all interfaces, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type :
> show surelink interface all
Interface
---------
eth1
eth1
eth
eth
modem
modem
>
IX10 User Guide
Test
-----------------------------
Interface is up
Interface's DNS servers (DNS)
Interface is up
Interface's DNS servers (DNS)
Interface is up
Interface's DNS servers (DNS)
Show Surelink status and statistics
show surelink interface all
Proto
Last Response
-----
-------------
IPv4
32 seconds
IPv4
28 seconds
IPv4
21 seconds
IPv4
20 seconds
IPv4
115 seconds
IPv4
114 seconds
command:
Status
-------
Passing
Passing
Passing
Passing
Passing
Passing
158
Advertisement
Table of Contents
