Interfaces
Show SureLink status and statistics
You can show SureLink status for all interfaces, or for an individual interface. You can also show
Surelink status for ipsec tunnels and OpenVPN clients.
SureLink status is only available from the Admin CLI.
Command line
Show SureLink State
To show the current state of SureLink for the IX20 device, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type:
> show surelink state
Test on network.interface.eth1.ipv6 with condition: one
dns_configured (n);
network.interface.eth1.ipv6;
ACTION
restart_interface
update_routing_table 00/01
Test on network.interface.modem.ipv4 with condition: all
dns_configured (n);
network.interface.modem.ipv4;
ACTION
update_routing_table 00/03
restart_interface
reset_modem
switch_sim
modem_power_cycle
restart_interface
>
Show SureLink status for all interfaces
To show the SureLink status all interfaces, use the
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
IX20 User Guide
-> update_routing_table
ATTEMPTS
STATUS
00/01
[FAILED]
-> restart_interface
ATTEMPTS
STATUS
[ BUSY ]
00/03
00/03
00/03
00/03
00/03
show surelink interface all
Show SureLink status and statistics
show surelink state
command:
command:
240