JVL MAC050 User Manual page 77

2.14
2.14.2 Configuration via MacTalk.
When using MacTalk for configuration the following parameters are used:
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Rotary table option
The desired Rotary table selection
is selected here at the Advanced
After the setup is done please remember to
save it in the permanent memory by pressing
the Save in Motor button.
The working range can be defined here
after selecting the type of turn table mode.
Minimum is the lowest position possible
to reach and maximum is the highest position
that can be reached. Both in encoder counts.
Both values are refering to the zero
position found during the optional Homing
or alternatively the zero point defined if using
an absolute multiturn encoder.
TT1185-01GB
tab.
73