JVL MAC050 User Manual page 453

6.14
6.14.2 Connectors / connector kits
MAC00-CONKIT1
This kit contains all 3 connectors for the Basic Mac Motor.
Power connector:
RS232 Connector:
I/O Connector:
By ordering this connector kit, all of the above-mentioned parts are included. Please en-
sure that a proper crimp tool is used when the contacts are fitted. The type numbers
mentioned in brackets are the original type numbers from either Molex or AMP.
6.14.3 Power Supplies
PSU00-PD1
Combined power dump, resistor, and capacitor unit. For a complete power supply sys-
tem, only a transformer with a secondary winding supplying 32VAC is required.
For systems with up to 5-8 MAC motors, this unit can serve as a central power dump
unit.
The capacitor offers an efficient and economical way of storing the energy returned from
the motors during deceleration of high inertias. See also
PSU48-480
A compact switch-mode power supply with 480W output power at 48VDC.
The power supply is UL and CSA approved. It is protected against overvoltage, overtem-
perature and short-circuit or overload of the output. The power supply can either be
mounted on a DIN rail or "wall" mounted. See also the data-sheet LD0047-xx which can
be downloaded at
Other power supplies:
JVL offers a wide range of power supplies in the power range 45W up to 1.5kW with the
output voltages 24 and 48VDC. They all uses switch-mode technology in order to mini-
mize physical dimensions and for easy adaption to mains voltages in the range 90 to
240VAC.
The product range covers the following types: PSU05-045, PSU24-120, PSU24-480,
PSU24-1000, PSU48-480, PSU48-1000, PSU48-1500 and PSU72-1000.
See also the data-sheet LD0058 (overview) or LD0053 (detailed) which can be down-
loaded at www.jvl.dk.
6.14.4 Brakes and shaft reinforcement
2 brake units are available for the MAC50-141 motors. The MAB23x-01 offers 10mm a
output shaft and MAB23x-02 offers 6.35mm output shaft. Both types can be mounted
directly on all the MAC50-141 motors and require 24VDC applied to release the motor
No brakes are available for the MAC400 and 800 since they are constructed with an in-
tegrated brake which is a part of the order number for the complete motor.
See also the data-sheet LD0055-xx which can be downloaded at www.jvl.dk.
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Accessories
JVL no. 3069-02
www.jvl.dk
Housing 2p. Pitch 3.96mm (Molex no. 09-91-0200).
JVL no. 2478-TLCrimp contacts (Molex no. 08-50-
0106).
JVL no. WG0200 Since this connector is very small
(pitch=1.5mm), it is supplied as an assembled con-
nector with 65mm cable. WG0200 is the JVL num-
ber.
JVL no. 254H08Housing 8p. Pitch 2.54mm (AMP
no. 770602-8)
JVL no. 4809C-P914LCrimp contacts (AMP no.
770601-1)
www.jvl.dk
449